Hello, The crankshaft sensor is situated in the next of the block here is a guide and diagrams listed below to assist you readjust the sensor out. Https://www.gimpppa.org/articles/crankshaft-angle-sensor-replacementCheck out the diagrams (Below). You re welcome let us know if you require anything rather to gain the difficulty fixed.Cheers


You are watching: 2005 dodge neon crankshaft position sensor location

*



*



My examine engine light came on a few weeks back. Its turn off now yet when I had actually it confirm at one autoparts store. Lock told me it to be the Crankshaft place Sensor.I had to drive prefer 20 miles to one auto keep that had the part. The employees over there told me it was straightforward to change. Take the end a bolt, unplug it. And plug it back in and also rebolt it. The trouble is.I have NO CLUE wherein IT IS LOCATED! nobody at any kind of of the auto component stores can tell me. And also ive also asked a mechanic friend. And also he claimed its approximately the engine block. Not close to the pullys and also its not near the alternator or oil filter like displayed on one site. PLEASE just let me understand where this stupid part is so ns can obtain it changed out
~ above the 2.0L, the is in ~ the best rear that the engine (pic. 1)On the 2.4L Turbo, the is in ~ the lower left behind of engine (pic. 2)Pic. 1

*

Pic. 2

*


ns am trying to change the crankshaft placing sensor in my 2003 neon, what is the procedure? thanks


See more: 7 Year Old Me Wondering How Do They Put A Car In The Middle Of The Mall S?

removed - 2.0, 2.4, 2.4L TURBO Fig.1 Crankshaft place Sensor Location

*

The Crankshaft place Sensor is in the front of the engine block just under the starter motor.Disconnect the negative battery cable. Progressive vehicle and support. ~ above 2.4L SRT-4, eliminate the reduced inner cooler hose from the metal tube.Fig.2 structure Collar and also Bending Strut - (Automatic Transaxle Equipped)

*

eliminate the structural Collar, describe the Engine, structural Collar Removal and also Installation section. Unlock and disconnect the electrical connector to the crankshaft position sensor. Remove the crankshaft place sensor bolt.Fig.3 Crankshaft place Sensor - 2.4L Turbo

*

eliminate the sensor.INSTALLATION - 2.0, 2.4, 2.4L Turbo inspect O-ring because that damage and lubricate the O-ring with engine oil before installing sensor. Use a twisting activity when installation the sensor. Install and tighten the crankshaft position sensor bolt and also tighten come 9 Nm (80 15 in. Lbs.) . Connect and also lock the electrical connector to the crankshaft place sensor. Install the structure Collar, describe the Engine, structural Collar Removal and Installation section. Top top 2.4L SRT-4, install the lower inner cooler hose to metal tube and also tighten clamp. Reduced vehicle. Attach the an adverse battery cable.https://www.gimpppa.org/kpages/auto_repair_manuals_alldata.htm