Despite the Accord"s substantially high rank on the many stolen car list, one additional annoyance is a malfunctioning factory security system. Learn how to disable the security system with this how-to.


This article applies to the Honda Accord (1990-2002).

You are watching: 1999 honda accord alarm, disable

Despite Honda"s call for reliability, particular Honda Accord models additionally have a propensity to endure security system malfunctions. This have the right to be rather problematic once the alarm randomly goes off at 4 in the morning, waking up her family and your neighbors. Fortunately, friend can adjust the sensitivity or disable the manufacturing facility security device yourself, and also put a prevent to the ongoing racket. If you"re uncomfortable playing v wires, uncover a reliable shop that can gain the job done, but likewise expect to salary a pretty penny. Here"s a DIY overview to effectively disable her alarm.


Adjusting the Sensitivity

Step 1 – adjust the settings

If friend don"t desire to fully disable the security system, you can change the mechanism with a flat head screwdriver. Underneath the driver"s next dashboard is a regulate unit because that the security system. There you deserve to lower the sensitivity by adjusting the knob to your desired setting. Perform not collection the sensitivity too low or the alarm might not activate in ~ all—even if the glass breaks.

*
Figure 1. Chart of the Honda Accord"s protection system regulate box.

Disabling the factory Security System

Step 1 – Disconnect the wire harness

To fully disable the factory security system, merely disconnect the harness the powers it. A green, two-pin plug is located by the hood latch, and it is attached come the grille by six screws. Pull the latch on the plug and also slide the two-wire bundle out.

*
Figure 2. A two-pin connector because that the Honda Accord"s protection system.Step 2 – Shorten the two-pin cable harness

Strip the rubber or plastic insulators indigenous both ends of the wire, and then push each finish into the female slots of the wire harness. Use a plastic zip tie to fasten the connector come the structure or totally remove the connector by removing the six screws holding the in place.

See more: Where Is The Gym In Gta San Andreas, Where Can I Find All The Gym

*
Figure 3. A thin piece of wire can be supplied to shorten the two-pin wire harness.

Featured Video: just how to Disable the factory Alarm